Allard Krings that is micro-SD off course!

Adam Hartley hi Adam, thanks a lot for your help! I was indeed able to install ubuntu on the NVME-drive. However fter rebooting the sbc had a reallocation-error. After some searching on internet I found a tip replacing the firmware that Starfive provides by the one from Ubuntu. This is obligatory if you have the 1.2a revision! Now ubuntu boots fine from yhe NVME-drive, no SSD needed!

Adam Hartley Helo , i am not even getting to the point where I can replace the DTB. This is my ouput: Model: StarFive VisionFive V2 Net: eth0: ethernet@16030000, eth1: ethernet@16040000 Hit any key to stop autoboot: 0 StarFive # pci enum starfive_pcie pcie@2B000000: Port link up. starfive_pcie pcie@2B000000: Starfive PCIe bus probed. PCI: Failed autoconfig bar 10 starfive_pcie pcie@2C000000: Port link up. starfive_pcie pcie@2C000000: Starfive PCIe bus probed. PCI: Failed autoconfig bar 10 StarFive # nvme scan StarFive # load mmc 0:1 $fdt_addr_r dtb/starfive/jh7110-starfive-visionfive-2-v1.2a.dtb Card did not respond to voltage select! : -110 Couldn't find partition mmc 0:1 Can't set block device StarFive #

Adam Hartley Hi, I have the 1.2A version of the board with an NVME installed. Following the tutorial does not work. Is it possible at all to install ubuntu on that? Even on a simple SD card it does not boot. If so , what step should I do differently from your tutorial?